Installation floor method describes the precautions for installing the floor

The friends who need decoration in the home pay attention. Now when you need to install the floor , you can take a look at our website. These are some methods for installing the floor, and you must know when you are installing the floor. What are the precautions for installing the floor? I hope that if you look at it, there will be a lot of help. After understanding our installation floor knowledge, it is not too late to buy the floor.


安装地板


First, the introduction of the installation method


1, grassroots cleaning


The base level is required to be flat, dry and clean. If the ground floor of the building or the bungalow is laid, it must be waterproofed. The floor must be cleaned before paving the floor.


2, laying the keel


Before laying the keel, the ground should be leveled first. When the ground height difference is too large, use the shovel to level. The wooden keel is fixed on the ground by using a hammer to drill or nail the keel and the keel. The distance between the keel and the wall or other materials is 8-12 mm. The paved keel should be leveled and firmly inspected, and the floor can be laid after passing the test.


3, laying plastic film mats


The cushioning material can be used with a 3mm thick foam pad with a plastic film or a padded treasure with a thickness of 10-12mm. It is also possible to use high-quality multi-layer plywood with a thickness of 9-18mm, which is fixed on the ground, and must be nailed firmly around the board. Leave a gap of 3-6mm between the board and the board, and seal it with tape.


4, paving the floor


The direction of the pavement floor is usually the same as the direction of the room. From left to right or from right to left, the paving is arranged one by one, the groove is facing the wall, and the wooden wedge is placed between the floor and the wall to leave the expansion joint. In dry areas, the floor is wet, the expansion joints should be kept small, and the expansion joints in wet areas should be kept large.


安装地板


5, install the skirting board


For skirting board installation, the thickness of the optional skirting board should be greater than 1.2cm. During the installation, the floor expansion joint gap is within 5-12mm, and the polystyrene board or elastomer is used to fill in the gap to prevent the floor from loosening. Install the skirting board and be sure to cover the stretch seam.


Second, install the floor precautions


1. Selected paving time and environment: The material of the floor itself is natural wood, and the requirements for ambient temperature and humidity are relatively high. Generally, the temperature of the floor covering is suitable between 16 ° C and 30 ° C, so that the timber floor can be kept in an optimal state in nature. From the seasons, the spring and autumn seasons are more suitable than the summer and winter seasons. In the 24 hours a day, try to avoid noon and evening construction, preferably after 2 pm.


2. Moisture-proof treatment of materials: Floor materials should be stored at room temperature for two days before paving. In order to better protect against moisture, the floor should be stored in a ventilated and dry place and protected with a plastic film. Floors that have already been tidal are more prone to mold and their service life is greatly shortened. They cannot be dried and reused. The purchased floor is also subjected to a moisture-proof treatment before laying. Apply a layer of moisture-proof protective paint to the reverse side of the floor to prevent the wet floor from affecting the floor, resulting in a floor hollow.


3, moisture-proof floor mats should pay attention to: If the ground environment is relatively wet, in addition to waterproofing, it is also necessary to use pearl cotton or aluminum film and other waterproof materials to do the substrate treatment, to ensure the ground is dry, and then glued Flooring. When laying the floor mats, pay attention to the fact that the floor mats must be laid flat and cannot be empty; and the mats must be firmly adhered to the ground. Do not stick glue around the mats, which will seriously affect the moisture of the ground. Features.


The content introduction is what the friends have to learn how to install the floor, and when you are doing this installation, there are also some precautions. Our decoration home network also has some decorative information, which can help everyone, Xiaobian I hope my friends can continue to pay attention.


Fused Glass Mosaic Pieces

C&K MOSAIC , https://www.cnkmosaictile.com

Posted on