Stair anti-skid strip installation method stair anti-skid strip anti-skid principle

With the improvement of people's living standards, many people have lived in the second floor of the small bungalows. The essential part of the building is the stair anti-slip strip. The stair anti-slip strip can guarantee the safety of our up and down stairs to a certain extent. What are the installation methods for the stair anti-slip strip? What is the anti-slip principle of stair anti-skid strips ? In the following section, we will introduce you to everyone!


楼梯防滑条


First, the specific installation method of the stair anti-skid strip


1. The plane and elevation of the stairs should be 90 degrees. Clean the stairs first, apply the universal glue on the front edge of the stairs and the back of the stair anti-slip strip, and then dry it and stick it. Use a rubber hammer to hammer the joint. can.


2. Or punch holes in the aluminum alloy base, fix the stair anti-slip strip on the stair surface with screws, and finally insert the rubber strip on the surface. If the special angled metal buckle is used to fix the two ends of the wrap angle, the anti-skid strip can be prevented from shrinking and falling off, and the high-grade appearance is also achieved.


Second, the anti-skid principle of the stair anti-skid groove


1. The stairs are slippery. This is also a major problem. Most stair steps are laid with artificially fired floor tiles or granite, marble and other stone, as well as iron stairs and wooden stairs. Generally speaking, the harder the ground material, the lower the water absorption rate, the better the lightness, and the smoother the ground.


2. The stairs are narrow. Generally, the stair step width is about 30-35 cm. It is rare to have less than 30 cm, the step is too narrow, the contact area is small, the center of gravity is unstable, and it is easy to fall.


3. The number of stairs is too large and steep. Generally, there is a turning platform on the higher floor stairs, which is not only an aesthetic problem, but also a safety consideration. The stairs are about 12 steps from the first floor to the platform, and the same is true for the platform. You will also see the stairs that have no platform in one step. If you have more than 20 steps, it will be very steep. Once you fall, the consequences will be very serious.


楼梯防滑条


Second, how to clean and maintain the stair anti-skid strip


1. Before each cleaning, the cleaning tools used, such as: mop, long handle brush, wiper, water absorbing machine, grinding machine, etc., must be cleaned first to ensure that the cleaning tool is used in a clean state to avoid The floor is not contaminated by secondary oil during cleaning.


2, after the anti-slip treatment of the ground, need to be cleaned regularly, such as: (the kitchen needs to keep daily) with alkaline cleaning solution or porcelain surface alkaline cleaner with water or warm water diluted to 1:7-10 concentration (oily special Weight can be reduced to the proportion of the preparation) evenly spilled or applied to the ground with a flat drag, and then brushed with a long handle brush or a scrubber.


3. Rinse with clean water, and then use a clean mop to dry or wipe the wiper or blot dry.


4, usually keep the mop in a clean state, use a plastic box to install half a box of water, add detergent or detergent, remove the mop cloth after each use, put it in it for about 20 minutes before removing Rinse with water to dry and use. If some of the ground is greasy, it should be cleaned regularly. The anti-slip effect is still the same.


In addition, we should clean the stairs during the installation of the stair anti-slip strips, so it is easier to operate during the operation. You can see how important the stair anti-slip strips are, and today's content ends here. Want to know more about decoration consultation, please pay attention to the decoration home network!


2000m Laser Rangefinder Module

2000M Laser Rangefinder Module,Long Distance Laser Rangefinder,Laser Range Finder Sensor,Targeting Optics Module

Rxiry (Jiangsu) Optoelectronic Co., Ltd , https://www.rxiryrangefinder.com

Posted on