In modern homes, there are almost every shower room. However, we don’t know much about the safety of the shower room. How can we install a high quality and safe shower room? Let’s take a look at the precautions. .
Glass selection: tempered glass + explosion-proof membrane
Tempered glass is relatively safe glass, but many people think that tempered glass is explosion-proof glass. In fact, the two are not equivalent. Different brands and prices have great differences in quality. In addition, tempered glass also has a self-detonation rate of three thousandths. Therefore, the following points should be noted when purchasing the shower glass:
First of all, there must be the most basic quality assurance - 3C certification mark. It is more secure to use the laser to print on the glass than the attached logo.
Next, look at the thickness of the glass. Too thin glass is unsafe, too thick and practical. It is generally recommended to choose a glass with a thickness of 6-8mm, and the sound is crisp and the surface is faintly textured. Also, pay attention to whether the edge of the glass is flat. When installing, check whether the edge of the glass is damaged, the corners are leveled, etc., so as to avoid the hidden danger after installation.
There is also a practical little trick to bring sunglasses when you buy a shower room. If you see colored stripes on the glass, it is safe tempered glass.
Back to top material: aluminum thickness, hardness, finish
The robustness of the shower room is largely determined by the support back to the top. Usually back to the top is made of aluminum alloy, due to the need to support the weight of tens of kilograms, so the hardness of its aluminum will directly affect the safety and service life of the shower room:
Thickness - The thickness of high-quality aluminum ranges from 1.2mm to 1.5mm, and some can even reach 2mm. The upper aluminum glass is required to be 1.5mm or more.
Hardness - The hardness of the aluminum can be easily tested by pressing the aluminum frame by hand. It is usually difficult to press the aluminum to the deformed aluminum to a hardness of 13 degrees or more.
Finish - High-quality aluminum has a strong coating, bright color, and is not easily corroded, and its surface is bright and seamless.
Back to top accessories: handles, rails, wall clips can not be ignored
Although the hardware accessories are inconspicuous, they play a key role, especially the flexibility of the handles, rails, wall clips and the nesting of the shower room.
Handle - It is not recommended to use a flexible lever. Use a smooth, effortless and stable handle.
Slide rails - mainly the nesting between the pulley and the track and the glass is good, the gap is small, the sliding is smooth, and the pulley material of the general synthetic material is better.
Wall clamp - the wall clamp is the part where the shower room and the wall are connected. It has good vertical and horizontal adjustment ability, which can avoid the distortion of the glass during installation and use.
Check water tightness: focus on rubber strip
The watertightness of the shower room is mainly sealed by the rubber strip. When purchasing, the tightness of the shower strip should be strictly checked:
Strips - The strips between the glass are very tough, there will be no breakpoints at the hinges, and in order to avoid aging of the strips, they should be replaced every 1-2 years.
More Suzhou furniture purchase skills are available at http://
The light source (which is often also called a fiber optic projector or fibre optic illuminator) provides the illumination to any fibre optic lighting system. They contain the lamp or LED and any additional control gear to provide special lighting effects.
Light sources are the only part of a fibre optic system which contains electricity, and they are the only part that, depending on the type, can get warm to the touch.
Illuminators,Fibre Optic Illuminator,Led Fiber Optic Lights,Fiber Optic Illuminator,Fiber Optic Projector
Jiangxi Daishing POF Co.,Ltd , https://www.jxopticfibrelight.com